← Back to Volume 5, Issue 1

Calculation and Programming of Motion Coordinates for 5-axis Machining of Cubic B-splineinterpolating Surface

Geng Li
Vol.5, No.1, pp.32-41, 2025 DOI: 10.62051/ijmee.v5n1.05 February 27, 2025
Download PDF
Abstract: The control point of cubic B-spline interpolation surface is calculated inversely and the back cutter face is fitted according to the given profile value points. The movement coordinates of each axis of the five-axis grinding machine after the grinding wheel grinding are calculated. Using MATLAB software to draw the given original data, then calculate the μ-direction and ω-direction control points through the B-spline difference, and then generate the standard B-spline surface. According to the grinding principle of the five-axis grinding machine, coordinate changes are made, and finally the grinding track of the grinding wheel is calculated and visualized.
Keywords: Matlab, B-spline Interpolation Calculation, Grinding Motion
APA Citation: Geng Li (2025). Calculation and Programming of Motion Coordinates for 5-axis Machining of Cubic B-splineinterpolating Surface. International Journal of Mechanical and Electrical Engineering, 5(1), 32-41. https://doi.org/10.62051/ijmee.v5n1.05

References

  1. Chinese Mechanical Engineering Society heat treatment Society "Heat treatment manual" editorial board. Heat Treatment Manual: Volume 1. Beijing: China Machine Press, 2002:41-118.
  2. Yan HZ, Chen SH, Ming XZ et al. (2009). Study on the Influence of Machine Tool Adjustment Error on Spiral Bevel Gear Tooth Surface. China Mechanical Engineering, 20(1): 11-14. http://www.cmemo.org.cn/CN/.
  3. Min ZH, Feng J, Feng P. (2024). Optimization of numerical control vertical gear grinding machine. Machinery, 62(11):66-69.
  4. Zhao YP. (2023). Engineering Differential Geometry of Curves and Surfaces. Science Press.
  5. Feng J. (2017). Research on Key Technology of Spiral Bevel Gear CNC Machining, Harbin Institute of Technology Press.